How to replace the reel of 8018TTO thermal transfer printer? First of all, there are only four so-called replacement reels: push rod reel, ribbon guide reel, ribbon moving reel and tension reel. How do they change?
1. How to replace the push rod reel for 8018 thermal transfer printer?
The shaft body of the "Push Rod Reel" is an easy to wear part, it should be checked for damage and replaced if necessary.
Step 1 of changing the putter reel
1. Remove the stop screw from the end of the push rod spool.
Step 2 of changing the putter reel
2. Carefully remove the push rod reel, making sure not to drop any components.
Change the putter reel step three
3. Install and fasten the new push rod reel kit.
Step 4 of changing the putter reel
4. After fixing, rotate the reel to make sure it can move freely.
2. How to replace the ribbon guide reel for 8018 thermal transfer printer?
The ribbon guide reel is easily damaged if it is used improperly. If the reel is bent or damaged, it needs to be replaced. The steps are as follows:
Step 1 of replacing the ribbon guide reel
1. Remove the stop screw from the end of the guide roller.
Step 2 of replacing the ribbon guide reel
2. Carefully remove the ribbon guide spool, making sure not to drop any components.
Step 3 of replacing the ribbon guide reel
3. Install and fasten the new guide reel kit.
Step 4 of replacing the ribbon guide reel
4. After fixing, rotate the reel to make sure it can move freely.
3. How to replace the ribbon moving spool for 8018 thermal transfer printer?
If any part of the moving reel is damaged, the kit should be replaced.
The steps are as follows:
Turn off and disconnect the power to the device.
Step 1 of replacing the ribbon moving reel
1. Use a screwdriver or Allen Allen wrench to apply a little force to release the ribbon supply spool holder.
Step 2 of replacing the ribbon moving reel
2. Pull up and remove the reel.
Step 3 of replacing the ribbon moving reel
3. Remove the fixing screws on the reel box.
Step 4 of replacing the ribbon moving reel
4. Take out the reel and reel box from the main body of the printer.
Step 5 of replacing the ribbon moving reel
5. Load the new kit and fix it.
4. How to replace the ribbon tension reel for 8018 thermal transfer printer?
If the tension reel is damaged, the entire kit may need to be replaced.
The steps are as follows:
Turn off and disconnect the power to the device.
Step 1 of replacing the ribbon tension reel
1. Remove the stop screw from the ribbon tension spool kit.
Step 2 of replacing the ribbon tension reel
2. Remove the kit from the shaft. Make sure that there is no missing spring.
Step 3 of replacing the ribbon tension reel
3. Remove the stop screw on the reel.
Step 4 of replacing the ribbon tension reel
4. Load the new kit and fix it.
When installing the replacement kit, make sure that the spring is placed toward the outer edge of the thermal transfer printer body. Due to the proximity of the magnet, a small tool may be required to hold the spring in place when installing the new kit.
Note: The tension sensor is easily damaged, so be careful not to damage the sensor when replacing the kit.
Note: Once the tension sensor is installed, it needs to be recalibrated.
