Barcode printers are different from the inkjet printers, laser printers, and dot-printer printers that we usually contact. Barcode printers plan for bar code-related knowledge, so how to use barcode printers? The following Hongshan barcode printer manufacturers are for everyone. Brief introduction:
I. Unpacking inspection:
不用 Needless to say this step, just check the packing list, a brief start. However, if you find that the actual item is inconsistent with the list item, remember to contact the seller to check and acknowledge, so as not to affect the normal operation.
2, device consumables:
1. When installing labels and ribbons, just follow the device instructions in the barcode printer.
Note: When the ribbon device is installed, it is necessary to distinguish the winding direction of the ribbon. Do not install it in reverse, otherwise it will endanger the components of the barcode printer. When installing the device, the ribbon must be pushed to the far left. The ribbon hook must be in the ribbon slot. Inside.
2. When installing labels and ribbons, be careful not to scratch the print head. Things like rings, tools and more. The ribbon and label should not be covered with sand, dust and other debris.
3. When a new label is installed for the first time, the printer will do the paper measurement job.
4. After installing the label and ribbon, be sure to close the iron cover.
5. Please use high-quality ribbons and labels, otherwise, it is easy to endanger the print head.
Three, online power:
The power switch is located behind the printer, and you can see a 230V or 110V toggle switch.
When installing the printer, please pay attention to check the position of the toggle switch to ensure that the operating voltage of the barcode printer matches the power supply voltage. Check whether the power supply is connected to a safe ground.
Note: When plugging or unplugging any wires, the power of the microcomputer and barcode printer should be closed. Otherwise, the motherboard of the barcode printer and the microcomputer may be easily damaged. Some external influences, such as lightning, noise on the power supply or signal line, can also cause the barcode printer to malfunction. Turn off the bar code printer and turn it on again to return the bar code printer to normal.
4. Calibration before printing:
装置 After the consumables are installed and powered on, the labels and ribbons need to be calibrated. After the calibration is successful, the printing can be ensured accurately.
V. Daily Protection:
The print head is classified as a delicate part, and the printer is in a working state during operation, which is relatively easy to be damaged. Therefore, it is necessary to pay attention to cleaning and maintenance often. It is recommended that the maintenance cycle be three labels or one ribbon after printing.
Protection method: Turn off the printer's power supply, use cotton swabs to drench more than 99% industrial alcohol, and scrub the surface of the print hair hotline in one direction. After cleaning, wait for the alcohol to evaporate before powering on.
